Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
MX ONE Server to Alcatel
- Thread starter jaylek
- Start date
Is it black fiber? (or already coneccted with some terminals) If yes you need to have two terminals which emulate E1 link over fiber and then you may use PRI/QSIG to connect two systems.
Just think that instead of the fibre you had one copper pair; you would have installed two SHDSL modems with E1 interface in each side of the pair (if the length of the pair is inside the requirements of this configuration) and then each of the systems would have been connected to each of the modems.
If already there are IP terminals in each end installed you may go for SIP trunking (if TSE)
Just think that instead of the fibre you had one copper pair; you would have installed two SHDSL modems with E1 interface in each side of the pair (if the length of the pair is inside the requirements of this configuration) and then each of the systems would have been connected to each of the modems.
If already there are IP terminals in each end installed you may go for SIP trunking (if TSE)
- Status
Similar threads
- Locked
- Question
- Locked
- Question
