MX-One 3.1 T-1 CAS

[TeleLion]

MA trying to test a T-1 CAS in MX-One 3.1 SP1, it's not working on the custmer site, and am trying to simulate the configuration here in my Lab, where i have a TSW SP0 act as my PSTN (CO), am using TLU77/3 at both sides, will this work with the following parameters:
********MX One 3.1 side******************
MDSH> rocap:rou=3;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
3 1110000000000010 5 3010030000 0 30 128 00151514 211000000000 001100

END

MDSH> rodap:rou=3;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
3 TL45 H'00000003 H'00000006 H'00000007 NO

END

MDSH> roddp:dest=91;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
91 3 000500000000025000000000000 0 1 0

END

MDSH> roedp:rou=3,tru=all;
ROUTE EQUIPMENT DATA
ROU TRU EQU IP ADDRESS SQU INDDAT CNTRL
3 002-1 002-0-70-00 H'000000000000
3 002-2 002-0-70-01 H'000000000000
3 002-3 002-0-70-02 H'000000000000
3 002-4 002-0-70-03 H'000000000000
3 002-5 002-0-70-04 H'000000000000
3 002-6 002-0-70-05 H'000000000000
3 002-7 002-0-70-06 H'000000000000
3 002-8 002-0-70-07 H'000000000000
3 002-9 002-0-70-08 H'000000000000
3 002-10 002-0-70-09 H'000000000000
3 002-11 002-0-70-10 H'000000000000
3 002-12 002-0-70-11 H'000000000000
3 002-13 002-0-70-12 H'000000000000
3 002-14 002-0-70-13 H'000000000000
3 002-15 002-0-70-14 H'000000000000
3 002-16 002-0-70-15 H'000000000000
3 002-17 002-0-70-16 H'000000000000
3 002-18 002-0-70-17 H'000000000000
3 002-19 002-0-70-18 H'000000000000
3 002-20 002-0-70-19 H'000000000000
3 002-21 002-0-70-20 H'000000000000
3 002-22 002-0-70-21 H'000000000000
3 002-23 002-0-70-22 H'000000000000

END

*********TSW side(imulating PSTN CO)**************
<rodap:rou=4;ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
4 TL45 H'00000003 H'00000006 H'00000007 NO

END

<rocap:rou=4;ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
4 1110000000000010 5 3010030000 0 30 128 00151514 211000000000 001100

END

<roddp:dest=17;EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
17 4 00050000000002500000000000 0 1 0

END

<roedp:rou=4,tru=all;ROUTE EQUIPMENT DATA
ROU TRU EQU IP ADDRESS SQU INDDAT CNTRL
4 001-1 001-1-10-00 H'000000000000
4 001-2 001-1-10-01 H'000000000000
4 001-3 001-1-10-02 H'000000000000
4 001-4 001-1-10-03 H'000000000000
4 001-5 001-1-10-04 H'000000000000
4 001-6 001-1-10-05 H'000000000000
4 001-7 001-1-10-06 H'000000000000
4 001-8 001-1-10-07 H'000000000000
4 001-9 001-1-10-08 H'000000000000
4 001-10 001-1-10-09 H'000000000000
4 001-11 001-1-10-10 H'000000000000
4 001-12 001-1-10-11 H'000000000000
4 001-13 001-1-10-12 H'000000000000
4 001-14 001-1-10-13 H'000000000000
4 001-15 001-1-10-14 H'000000000000
4 001-16 001-1-10-15 H'000000000000
4 001-17 001-1-10-16 H'000000000000
4 001-18 001-1-10-17 H'000000000000
4 001-19 001-1-10-18 H'000000000000
4 001-20 001-1-10-19 H'000000000000
4 001-21 001-1-10-20 H'000000000000
4 001-22 001-1-10-21 H'000000000000
4 001-23 001-1-10-22 H'000000000000

END

Am not sure if this is even possible to test a T-1 CAS tieline, where i have the MX-One 3.1 SP1 connected to a TSW through TLU77/3 where the TSW simulates a CO (PSTN)?!!

To MD or not to MD that is the question