MWI light constantly flashing - HELP

[mmcbeath]

Deleted analogue extension and plid. Used same extension and programmed a voip phone (Mitel 5330). As soon as i boot up phone MWI light is flashing no messages. My belief is that the analogue extension has a message waiting but beings it was never deleted its stored somewhere but i cannot find it.

 

[kwbMitel]

Not likely to be related to the analog station due to hardware types.

What type of message waiting? (locate feature extension XXXX)

Where does the call take you if you use the msg key to return the call?

Have you read the FAQ on MWI's?

**********************************************
What's most important is that you realise ... There is no spoon.

 

[mmcbeath]

The locate feature extension is as follows:

IP Device ID: 10
Circuit Location : 1 3 1 10 1
Extension : 7127
Active Features :
Message Waiting Lamp On
Dialed Message Waiting.
Phone Lock: UnLocked
MAC Address : 08:00:0F:64:7C:89

The call takes you no where as their is no message when you hit the message button

 

[kwbMitel]

Check your feature access codes for the Dialled Message Waiting cancel code

Dial code + ext to remove lamp.

If you are using embedded Mail, Is the last port of the VM in the Hunt Group? If not, make it so.

**********************************************
What's most important is that you realise ... There is no spoon.

 

[mmcbeath]

Thanks a lot for your help. I will dial the code tomorrow and let you know the verdict.

 

[mmcbeath]

Worked for me thanks a lot for your help again!