I have 6 subreports one after each other in a report. Currently I have put then in the group header based on a value being passed to the main report.
I have made each report height very small and switched on the cangrow and canshrink properties for each one.
Then I wrote a group_header_format where I set the top of the next subreport to equal the top + height of the previous subreport. This place the subreports after each other.
Ok, my problem is when I reach the end of the page. The top value for the subreport is too large. Also when I display the values of the top for each subreport they are using the original designer values and not the position during format. I need the subreports to move to the next page if the first page is full, HOW DO I DO THIS?? ANY IDEAS ANYONE!
I have made each report height very small and switched on the cangrow and canshrink properties for each one.
Then I wrote a group_header_format where I set the top of the next subreport to equal the top + height of the previous subreport. This place the subreports after each other.
Ok, my problem is when I reach the end of the page. The top value for the subreport is too large. Also when I display the values of the top for each subreport they are using the original designer values and not the position during format. I need the subreports to move to the next page if the first page is full, HOW DO I DO THIS?? ANY IDEAS ANYONE!
