Multiple ELU32s in 1 LIM

[tdoc43]

I have 2 ELU's in one LIM that are connected to different networks that are phisically seperated, no router between them. I have my 4425 directly registering with the ELU32 on its own network, no gatekeeper discovery is being used.

Everything is working fine with the IP phone as long as they do not try to make 2 simultaneous calls, such as trying to transfer a call to another station. The destination telephone rings, the destination telephone answers, but there is no audio either direction.

What I have found out using Ethereal is that the MD110 is telling the 4425 in the setup message to use the second ELU32 for the RTP packets. I can see the 4425 sending RTP packets to the second ELU32, but obviously nobody is listening as there is no routing between the two networks.

This happens also when another terminal is on a gateway call and a second terminal tries to make a call. The first call uses the local ELU32 and the second call uses the other.

I am at BC12sp8 and the 4425 is at R2B/R4H/R4B.

How, in the MD, do I tell it to only use the gatway that the terminal is registered?

Thanks for your input.

 

[TripleT]

You cannot have 2 x ELU32's in the same Lim but connected to different Networks.

You must have all ELU32's in the same Network.

However you can have 1 xELU32 in Lim 1 on a Network and another ELU32 in another Lim on a different Network.