Moving station and trunk modules to different ports

[jr6674]

Hello,

I have 2 systems with xc 6.1 with 2 combo service cartridage in two different locations on one system I will be moving station modules on port 3,4,5 to ports 10,11,12 and then will be adding trunk modles to ports 3,4,5 (already have trunk modules on ports 8,7,6). On the second system I will be converting trunk module on port 8 to a 3rd T1, and will be removing trunk module on port 3 to add a station module in its place since my ports 9,10.11,12 are all full.

Question?

As far as trunk modules I know that the line numbering will change, and I know that the port numbering will change for the station modules.

BUT??IS THERE SOMETHING ELSE I SHOULD BE AWARE OF, OR A PROPER PROCEDURE THAT NEEDS TO BE DONE, OR SOMETHING TO WATCH OUT, OR IS IT JUST MOVE THE TRUNK MODULES AND RE-DO THE LINE POOLS AND RE-ASSIGNED THE LINES TO THE PHONES AND AA AND NOTHING ELSE TO WORRIED ABOUT??

THANKS

 

[johnpoole]

unless you have a ton of programming i would power down, get the hardware where i want it, power up and do a startup. jmo

john poole
bellsouth business
columbia,sc