Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Moving Loops
- Thread starter BAKJANO
- Start date
12-0-0 would be a card on an ipe shelf what sort of card is it?
If its a card with sets on eg. FALC/DLC use mov in LD 20 to indivdually move the units to the new card.
Most other cards just print the TNs l s c u then delete and recreate them.
If its a card with sets on eg. FALC/DLC use mov in LD 20 to indivdually move the units to the new card.
Most other cards just print the TNs l s c u then delete and recreate them.
- Thread starter
- #3
acewarlock
Technical User
Your going to have to MOV 1 at a time, should take about 20 sec for each one, beats outing and rebuilding them.
I never tried this but you could try, I don't think it will work though.
REQ MOV 16
TYPE 3904 or whatever your moving.
This is a Signature and not part of the answer, it appears on every reply.
This is an Analogy so don't take it personally as some have.
Why change the engine if all you need is to change the spark plugs.
I never tried this but you could try, I don't think it will work though.
REQ MOV 16
TYPE 3904 or whatever your moving.
This is a Signature and not part of the answer, it appears on every reply.
This is an Analogy so don't take it personally as some have.
Why change the engine if all you need is to change the spark plugs.
acewarlock's recommendation is valid. I've added, deleted and moved multiple phones using this method. I've found the moves to be more reliable when I move them in groups of not more than 8. I had it happen a couple of times where a phone got "lost in transit" when I was moving more than 8 at the same time.
One thing to be aware of, though I don't think it will apply in this case but perhaps in the future, is that you NEVER want to move a Symposium linked phone in software. Even if the phone has been de-aquired by the Symposium, it can screw things up (I recall a Nortel Tech Bulletin about this some years back).
I'm curious. Since both card slots are in the same loop/shelf, why do you need to move the card from slot 0 to slot 5?
One thing to be aware of, though I don't think it will apply in this case but perhaps in the future, is that you NEVER want to move a Symposium linked phone in software. Even if the phone has been de-aquired by the Symposium, it can screw things up (I recall a Nortel Tech Bulletin about this some years back).
I'm curious. Since both card slots are in the same loop/shelf, why do you need to move the card from slot 0 to slot 5?
acewarlock
Technical User
That's good JP, I forgot about that 1.
This is a Signature and not part of the answer, it appears on every reply.
This is an Analogy so don't take it personally as some have.
Why change the engine if all you need is to change the spark plugs.
This is a Signature and not part of the answer, it appears on every reply.
This is an Analogy so don't take it personally as some have.
Why change the engine if all you need is to change the spark plugs.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question