Moving IPS with new IP address?

[chipig]

Hi,

We have 2 IPS and 1 IVS.

I'm about to move an IPS to a new location with a different IP address.

IP address of IPS#1 is 10.150.64.x.
IP address of IPS#2 (the one I'm moving) is 10.150.32.X.

I have to change the Lan interface and the IP-PAD adress of our IPS#2 to 10.150.64.x.
I know where to change these two settings in Matworx.

I'd like to know what else has to be done to make sure both PBX will keep communicating together.
Any tips would be greatly appreciated.

 

[belevedere]

Back up to the flash ROM then reset the PBX.

 

[chipig]

Ok thanx, but I still don't see how PBX#1 can talk to PBX#2 if I do not set the IP address of PBX#2 somewhere in PBX#1...

 

[belevedere]

If you are talking about IPCCIS between two sites then you should call in a qualified tech. A working knowledge of LCR is essential.
The following commands are involved;
0B00/00/01/02 =CPU IP address/subnet/gw
0A01/02/03 =PAD card IP address/subnet/gw
8A4007/8AXXX/8A5XXX/167/168 =Network LCR
5B01/XXXXX =Network LCR to destination IP address

 

[chipig]

Thanx a lot belevedere!

You gave me enough information to get it working.
The IPCCIS was already done,so here is what I did to move the PBX:

Commands on PBX1:

5B01>02100:010150064006- (New destination CPU IP address)

Commands on PBX2: (The one I'm moving)

IP LAN interface:

0B00>00:010150064006-
0B00>01:255255252000-
0B00>02:010150064001-

IP PAD:

0A01>00:010150064005-
0A02>00:255255255000-
0A03>00:010150064001-

save and reset