move TIE circuit to anothe slot in the system

[CommoGuy101]

Morning all,
Over the weekend I had a TIE trunk go down that connects a 1000E to the 1000M
Turns out that the TMDI card took a hit and possibly the slot.
I am looking to move the circuit to another open slot.(was 24 1 1....need to get it to 32 0 1)
Can anyone assist with the steps and procedures that I may need to do?
I have already disabled the loop, DCH, and the TMDI of the current configuration.

Any help would be appreciated.

Thank you,
CommoGuy101

 

[KCFLHRC]

You will have to out
1. The DCH in LD 17
2. The B-channels in LD 14
3. The Loop in LD 17 under DLOP
4. You will have to out the clocking at some point in LD 73

Then build it back in reverse order