Modify Number A presentation display.

[Amparo]

Hello.

I have a problem.

In one of the gateways I have a QSIG connected to the cell phone network. This network include in the number A the code 055 (customer code).

In the display of the telephone cisco i see the customer code and the number of the mobile phone.

You can remove the client code will not appear on the display?

Thank you very much in advance

 

[jeter]

Could you post a configuration of the router? We need to see how it's setup.


Go Army!
Tek-TIP Member 19,650

 

[Amparo]

The Gateway is a Gateway controller witch MGCP. The configuration is all in the CCM. In the gateway only is configuration the MGCP and the card of voice.

Don´t have any dial-peer, transaltion rule ,etc...

I,ve tried many configurations (translation patter, route patter (are only to outcoming-call), filters, but nothing parameter in this command modify the number A to number A of new)

Thanks.

 

[jeter]

thats right QSIG only works with MGCP in CCM...

If you turn up your dial analyzer does it follow your disired path?


















Go Army!
Tek-TIP Member 19,650

 

[iptuser]

You can make use of Translation Patterns in CCM for MGCP

Question

1. What do the internal DN`s start with ?

2. Is the cell mobile number a fixed length?

internal DN`s 2xxx
Mobile cell 10 digits long

1.Create a partition called "Delete 055"

2.Add this to the CSS of the Mobile GW so only the Delete 055 Partition is in it- remove all others

3.Create a new CSS "Internal only "with the Internal Partition of your Cluster- "Partition internal"

4.Create a translation pattern based upon the internal DN i.e 2xxx

5.With the same Translation Pattern I think Calling Party Transformation enter a number of X`s based upon the Cell number length
6. Add the CSS "Internal only" to the Translation Pattern


Calls shoudl now go to the TP and the calling CLI should now only show the Cell digits only

 

[iptuser]

You can make use of Translation Patterns in CCM for MGCP

Question

1. What do the internal DN`s start with ?

2. Is the cell mobile number a fixed length?

internal DN`s 2xxx
Mobile cell 10 digits long

1.Create a partition called "Delete 055"

2.Add this to the CSS of the Mobile GW so only the Delete 055 Partition is in it- remove all others

3.Create a new CSS "Internal only "with the Internal Partition of your Cluster- "Partition internal"

4.Create a translation pattern based upon the internal DN i.e 2xxx

5.With the same Translation Pattern I think Calling Party Transformation enter a number of X`s based upon the Cell number length
6. Add the CSS "Internal only" to the Translation Pattern


Calls should now go to the TP and the calling CLI should now only show the Cell digits only