How would I modify the default Ethernet shape so that if there are two separate Ethernet shapes each with a connection line crossing each other, on one of them one line at the crossover point draws a half circle so it shows the connections are not joined?
This is how the standard connector type of lines work. I think I need to change the line type in the shape from line to connector.
Is it possible to change the Ethernet shape to use the standard connectors or create a new shape based on the existing Ethernet shape using the standard connectors?
Thank You for your help.
This is how the standard connector type of lines work. I think I need to change the line type in the shape from line to connector.
Is it possible to change the Ethernet shape to use the standard connectors or create a new shape based on the existing Ethernet shape using the standard connectors?
Thank You for your help.