ModemDiag
Description: Displays diagnostic information about each modem as the modem’s call is cleared. The command is a toggle that alternately enables and disables the diagnostic display.
Usage: Enter modemdiag at the command prompt
According to Lucent's Admin Guide using this command will give you the following results.
TERMINATION REASON.......... LINK DISCONNECT
LAST TX data rate........... 26400 BPS
HIGHEST TX data rate........ 26400 BPS
LAST RX data rate........... 24000 BPS
HIGHEST RX data rate........ 24000 BPS
Error correction PROTOCOL... LAPM
Data COMPRESSION............ V42Bis
Line QUALITY................ 032
Receive LEVEL............... 017
Highest SPX Receive State... 67
Highest SPX Transmit State.. 67
What I am interested is the line QUALITY info. However, after I apply the command and send a fax the information above is not shown anywhere.
Just was wondering if anyone out there knows what I am doing wrong.
Thanks you all...
Description: Displays diagnostic information about each modem as the modem’s call is cleared. The command is a toggle that alternately enables and disables the diagnostic display.
Usage: Enter modemdiag at the command prompt
According to Lucent's Admin Guide using this command will give you the following results.
TERMINATION REASON.......... LINK DISCONNECT
LAST TX data rate........... 26400 BPS
HIGHEST TX data rate........ 26400 BPS
LAST RX data rate........... 24000 BPS
HIGHEST RX data rate........ 24000 BPS
Error correction PROTOCOL... LAPM
Data COMPRESSION............ V42Bis
Line QUALITY................ 032
Receive LEVEL............... 017
Highest SPX Receive State... 67
Highest SPX Transmit State.. 67
What I am interested is the line QUALITY info. However, after I apply the command and send a fax the information above is not shown anywhere.
Just was wondering if anyone out there knows what I am doing wrong.
Thanks you all...