modem Configuration 1

[tap]

I have tried and tried to get my modem to work but no joy
Here are my settings:-

Modem
Diagnostics

COM 1 No Modem Installed
COM 2 Serial Mouse
COM 3 SupraExpress 56i V PRO



-----------------------------------
More info

Port information
Port com 3
interupt 11
address 3EB
UART NS 1655OAN
Highest Speed 115K Baud

SupreExpress 56i V PRO

Identifier Responce
ATI1 255
ATI2 OK
ATI3 2.2.156.015e
ATI3 Supraexpress 56i V Pro
ATI3 Built: Jan 30 1999 10:24:24
ATI4 K56 V.90 Monopak DP
ATI5 180
ATI6 UK
ATI7 OK
AFCLA.. 0,1,8

-----------------------------------
Dos support (I get the following message)
The interrupt resource ( IRQ ) assigned to this modem may not match the interrupt that DOS applications should be configured to use. The correct settings for DOS applications using this modem are shown below.
No changes are required to the modem hardware settings, it is already correctly installed. This note only refers to configuring DOS applications that use this modem.No changes are required to the modem hardware settings, it is already correctly installed. This note only refers to configuring DOS applications that use this modem.No changes are required to the modem hardware settings, it is already correctly installed. This note only refers to configuring DOS applications that use this modem.

Com Port None
Base Address(HEX) None

Enumerator
IRQ None


----------------------------------
Resources
Input Request 11
input/output Range 03EF - 03EF

No conflicts

--------------------------------
Enumerator
HFCMODEM
supra2560 PCI Modem Enumerator
Resources
Input Request 11
Memory Range E1000000 - E100FFF
No Conflicts
------------------------------------------

I tried to change the settings but without any success,
I added the modem and installed it to com port 1 but got an error message that port could not be read from the regestry

I am sure that I have the correct drivers because I downloaded them form the Daimond site using the part number

I have an external 28k (motorolla) modem which I removed but obviously had to reinstall to get internet access this modem goes straight in on com port 1

What can I do to get the Diamond 56k modem to work?? PLEASE

 

[Comtech]

Boot to safe mode.
Remove all modems and com ports from device manager.
Restart, go into BIOS setup.
Set "PnP OS Installed" to NO.
Set "Reset configuration data" to "YES.
Disable com 1. <------VERY IMPORTANT.
Restart, reinstall. Cheers,
Jim

http://members.cnx.net/reboot/

 

[tap]

Thanks for your help
It gave me hope but araid it did not work ;(
is there anything else I can try?

thanks again

 

[Comtech]

A different driver.
There are 3 different ones on my modems page. Cheers,
Jim

http://members.cnx.net/reboot/