Hello,
I'm trying to setup a Wave Cast 1200AP, it works fine until I try to set WEP.
It's going to work as a Hub connected to a switch, our network has DHCP setup for all computers. But I've given the AP a static IP address. When I leave it with it's default settings I can connect and ping computers on the network...although it does drop out. Even though I'm standing around 2 metres away from it.
Then I set it to use 40 bit WEP, and then I can no longer connect to it, even though I've set my Laptop to the same Key Phrase as the AP.
Any ideas?
Matthew Collins
I'm trying to setup a Wave Cast 1200AP, it works fine until I try to set WEP.
It's going to work as a Hub connected to a switch, our network has DHCP setup for all computers. But I've given the AP a static IP address. When I leave it with it's default settings I can connect and ping computers on the network...although it does drop out. Even though I'm standing around 2 metres away from it.
Then I set it to use 40 bit WEP, and then I can no longer connect to it, even though I've set my Laptop to the same Key Phrase as the AP.
Any ideas?
Matthew Collins