mm716 analog port overhead paging

[afig]

We upgraded from a cs1000 where we had overhead paging using a bogen amp. During the upgrade, we assigned a port off the mm716 card and confirmed it worked by simply dialing the extension.

For some reason now, this will not work. The analog port will not "answer" despite being set to answer. All I can find on the internets is regarding setting up a trunk and assigning a TAC number. But I know this all worked without that up until recently.

 

[avayaguy23]

You need a bogen UTi1 attached to it.

https://www.bogen.com/product/singl...ingle-zone-universal-telephone-interface-uti1

 

[jimbojimbo]

I suggest you set it up on a MM711 and as avayaguy23 pointed out you need a paging interface.