MM with DS1/QSIG Connection

[btrain08]

I have MM connected to my PBX via 2 DS1/Qsig connections. The trunk group is setup with each member of the 2 DS1 boards alternating so we want the calls to hit each MAS server (we have 2) every other call. We just upgraded CM to 5.2 and migrated the MM DS1's from the old MCC to the new G650's, had to create 2 new DS1's in the switch (which were copied exactly from the old), changed to port in the signalling group and replaced the members with the new assignments. This is 1000% accurate and matching from the old and now the calls are all hitting MAS1 first and then overflowing to MAS2. When status'ng the trunk group it is not following the member assignments. Any ideas on where to fix that? it's not critical as it's working fine and taking calls, but we want to balance it out and don't know when this happened. It could have went awry when we upgraded the software a few weeks ago or when we migrated the boards over..

 

[texeric]

In your route pattern do you just have 1 route or 2? I'm assuming you just have 1. In your trunk group is your member assignments setup like this:
- Member 1 = port 1 on mas1
- Member 2 = port 1 on mas2
- Member 3 = port 2 on mas1
etc?

If so, are each DS1 in the same 650 or are they in different 650s? If they are in different 650s then this may be normal as the path of least travel may be going to one DS1 depending on where the call originates.

http://www.theviagroup.com

 

[btrain08]

You are correct on the member assignments and they originally were in the same PN on different carriers and now they are in different G650's on 2 different port networks.

 

[texeric]

Then most likely depending on where the calls are originating those calls would probably go to the same port network before diverting to a different port network.

http://www.theviagroup.com