i have a customer that wrote a custom program to click to dial out of a program. i can see their code where its connected to the IP address on port 4000 and the commands it sends. on the Axxess it works fine, on the 5k it does not attempt to make the call.
is there any documention on whats needed on the 6.3.x version of MiVoice Office 250 OAI commands and make the system dial a number?
they are also tapped in and blocking calls on the Axxess that come in via PRI and would need to get this working. its also connected to port 4000 on the CPS. they have thousands of numbers to block so using the call routing table to block is not really an option.
is there any documention on whats needed on the 6.3.x version of MiVoice Office 250 OAI commands and make the system dial a number?
they are also tapped in and blocking calls on the Axxess that come in via PRI and would need to get this working. its also connected to port 4000 on the CPS. they have thousands of numbers to block so using the call routing table to block is not really an option.