ronmarc900
Technical User
Have configured xnet for release 6, done profiling, xnet trunk group,COS,network elements, ARS ,ARS digits dialled, can not get it working
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Mitel release 6 - xnet configured but not working- help
- Thread starter ronmarc900
- Start date
- Status
There are dozens of ways this can fail due to improper setup.
Without specifics on what you have done, this will take forever.
Cluster Form
What are the member ID's and CEID's
ICP/PBX Form
IP addresses configured
Local controller set to local?
Total trunks configured
IP/Xnet Trk Profiles
What do you have here for each system
Is the trunk service number correct
does the trunk service number have the correct COS
does the trunk service number have the correct Absorb digits set to zero
IP/Xnet Trk Grps
What are the values here?
ARS
Digits Dialed
CEID for remote system setup details
route
Trunk Group / COR / Mod Digits
Modified Digits
Anything
Cor Groups
ANY CORs assigned to the COR group of the route?
Maintenance Commands
RMESSAGE VERIFY PBX [X] LAN (use this command from each system to the other)
State XNET ALL
**********************************************
What's most important is that you realise ... There is no spoon.
Without specifics on what you have done, this will take forever.
Cluster Form
What are the member ID's and CEID's
ICP/PBX Form
IP addresses configured
Local controller set to local?
Total trunks configured
IP/Xnet Trk Profiles
What do you have here for each system
Is the trunk service number correct
does the trunk service number have the correct COS
does the trunk service number have the correct Absorb digits set to zero
IP/Xnet Trk Grps
What are the values here?
ARS
Digits Dialed
CEID for remote system setup details
route
Trunk Group / COR / Mod Digits
Modified Digits
Anything
Cor Groups
ANY CORs assigned to the COR group of the route?
Maintenance Commands
RMESSAGE VERIFY PBX [X] LAN (use this command from each system to the other)
State XNET ALL
**********************************************
What's most important is that you realise ... There is no spoon.
@ Lundah - good point but I ran into issues with direct IP route a while back and I haven't revisited it.
I can't remember the issue unfortunately
I can do Clustering in my sleep so I have no issues with setup (except for once where I forgot to check the Local PBX option but I'd rather not talk about that)
**********************************************
What's most important is that you realise ... There is no spoon.
I can't remember the issue unfortunately
I can do Clustering in my sleep so I have no issues with setup (except for once where I forgot to check the Local PBX option but I'd rather not talk about that)
**********************************************
What's most important is that you realise ... There is no spoon.
- Status