Mitel 6940 Web UI 1

[TCSI17]

Hi,
Is there some process to enable the web UI of the 6940 for diagnostic purposes? I understand that if it's connected already to an MCD that it will use the system password assigned in the MCD.
When I browse to the IP address of the 6940 I just get page cannot be displayed. I never get the login page of the webUI. I've tried http as well as https.
I'm assuming by default it is enabled by the sounds of it, but maybe there is something in the MiVB that I have not enabled correctly?

 

[kwbMitel]

thread1329-1785277

**********************************************
What's most important is that you realise ... There is no spoon.

 

[TCSI17]

Thanks kwbMitel. That was exactly what it was. I tried to search the forum but didnt turn up that thread. thanks.

NOTE: for anyone reading this in the future, you need to disable the autocomplete in the Maintenance Command window prior to running the command as in the above link.
It will not allow you to type it in if you have autocomplete enabled.