Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Missing or Invalid Dat

Status
Not open for further replies.

glove

Technical User
Aug 24, 2000
42
US
On startup I'm getting the following error:

Missing or Invalid Dat: C:\Progra~1\Networ~1\Mcafee~1\Scan.dat C:\Progra~1\Networ~1\Mcafee~1\Names.dat C:\Progra~1\Networ~1\Mcafee~1\Clean.dat
Press any key to continue...

Any idea what is causing this?
 
Not sure what causes it, but I've seen it before too. Re-installing McAfee will get rid of the message - did it by chance happen after updating the DATs?
 
It did happen after updating the DATs. I found something on Mcafeehelp.com that said:

"The reason for this is the update or upgrade does not finish setting up until Windows finishes restarting. Sinch this message appears when Windows has not finished restarting, the update or upgrade has not been fully set up."

I went into the Windows Registry and under "DATFile" I changed it to a previous DAT file number so the virus update will think the DAT I installed has not been installed yet. Then I reinstalled the update and the error went away. The last update I installed was 4122, so I changed the registry to 4121.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top