Minimum hardware router configuration needed to run BGP multihomed.

[Glloq007]

Hi,

We'd like to setup a router connected to two different ISP.
A EBGP session will be set up to both of them.
Full routing table will be exchanged, meaning at least 251.000 prefixes on each connection.

My question is : Which Cisco hardware to used to support this configuration ? What should be the minimum capacity of RAM ?

 

[Minue]

Hello
I would go with a 2800 with 256MB of ram.If your'e on low budget 2600XM max out would work.
Regards