I have a Norstar MICS DR6.1 that I want to upgrade to MICS XC6.1. I am looking for any documentation on the proceedure but cannot find it. Can anybody point me to the Doc that expalains this?
Thanks,
The Installer guide should tell you. You just have to make sure you do not add or change any Hardware until after the Software upgrade is completed and tested. It should go somthing like this;
Back up system
Power Down
Put in New Software
Power System up and check programming.
Then if you need to add Hardware just power down system install new Hardware and power up system.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.