mics 7.1 cp 150 "no resource" message

[fireeater]

hey all

working in the office trying to check compatibility for cp and mics with call center and such.

any hoot
have mics 7.1 hooked up to cp150 3.1 (latest software 31.10.14.22)
boots OK, key codes OK, initializes OK,everything works good .
then all of a sudden, when doing the feature 983,981,985,ext i get "no resource" message on the set
reboot ,works again for a while then does the same thing
oh, just a note a couple of times when i did a feature code i got a digital crackling over the speaker before the error message came up
(cp manager access not affected )
have been using this cp for a while (spare in office for testing and use if one on site craps out)

have replaced software and still having same problem.

question is ,is the 150 pooched or is there anything i can do to it

thanks

_____________________________________
S.H.A.D.O.
_____________________________________

mike

 

[MikeDThePhoneGuy]

Couple of Q's:

1) Do you see the port lights and link light on the CP150 when you get those messages?

2) Have you tried testing the MICS ports or changing them?

3) Do you have a serial cable that you can hook up to your CP150 to watch the boot and then monitor from (have to leave the laptop hooked to it the whole time in order for the Hyperterminal or ProCOMM to get real time info)?

If after all that your still having the issue I would say that the main board of the CP is pooched...

 

[fireeater]

1 all light on and correct
2 have changed to different mics
still same

will hook up laptop and try

_____________________________________
S.H.A.D.O.
_____________________________________

mike

 

[curlycord]

Swapped PS?

BTW 31.10.36.22 is the latest.

once booted up, unplug all ports but main one....test, if of add next port and test etc.


=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[fireeater]

this is what i'm getting from the laptop
Starting voicemail
Country: NORTH AMERICA
Alternate QZ Mapping: 0
AMIS Address Start Key: #
Application SName: VM
Default Language {enum from country.c}: 0
Enable TT Gate: 0
Group List Lead Digit: 9
Key Language Toggle: 9
Key Operator Revert: 0
Login Mailbox Key: *
Local Number Length: 7
Maximum CLID display: 7
Maximum CLID entry: 16
Maximum Network DN Length: 16
Maximum Packet Network DN Length: 16
National Number Length: 10
SC Maximum Lines 10 20: 334
Voicemail CORE Ready...

this point all ok the after doing a feature code (works a few times the this

VCEPORT.C --->!! VOICE: DRM_SetPortCapability: chan 0 - rc 3001
VCEPORT.C --->!! VOICE: DRM_SetPortCapability: chan 0 - rc 3001
VCEPORT.C --->!! VOICE: DRM_SetPortCapability: chan 0 - rc 3001


another interesting thing i just noticed ,every few reboots i loose the call center enhanced, and mailbox upgrade key codes.
reboot and they are back , other codes ,callcenter basic and unified messaging stay

looking for spare power supply

_____________________________________
S.H.A.D.O.
_____________________________________

mike

 

[ironhorse17]

Had the same thing happen to me on a CP 100, you would reboot work for one or two log on then show no resource had to replace the unit.