MICS 6.1XC out bound dialing off of a Pri timing out. 3

[tincanphoneman]

The setup I'm working on is a Mics with a Pri and 6.1XC software, The customer needs a little more time dialing the number off of a Pri(it's timing out before they can input all the digits), are there any settings/timers I can change to accomidate them.
Thanks in advance.

 

[hawks]

In the dialing plan you can up the number of digits.

 

[clidpri]

Default is set at 4 sec
if you set it for 10sec and it took 5sec to dial then the call wont go through till the other 5 runs out
keep that in mind

 

[tincanphoneman]

Well I have some folks complaining that its too fast and some that it's too slow, if I up the number of digits what is the downside of it.

 

[curlycord]

What do you mean up the digits?

Try setting to 7 or 8 secs or
Set the slow dialers to use Pre-Dial (F82 maybe)

=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[joelunchpail]

under destination code
if 9 is your dest code set it to 11 digits or you won't be able to call LD. I'm not sure what the default is.
if you need overseas dialing you might need more digits.

 

[hawks]

By upping the digits in your dialing plan you are essentially increasing the time to dial out. Also like clidpri stated you could increase the Dial Out timer. I’ve used both in the past.

 

[joelunchpail]

if it is set for 7 digits then it will send after 7 digits and you will get the no such number recording from the co.
because it is looking for 10 digits for a local call