Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

MICS 0x32 Night service

Status
Not open for further replies.
kmpp

kmpp

Vendor
Joined
Feb 25, 2012
Messages
71
Location
US
I have a 0x32 with R1-T1 SW am trying to get night mode to work, they have a T1. The target lines start at 121 and on this old software there are no ringing groups, ext 500 is the control set for F871 and under lines I have 121 assigned with the voice mail port, so I am not sure what I am missing to make this work? Been a while since I have dealt with this SW.
Thanks in advance for any help.
 
Sort by date Sort by votes
Night service does not answer when f871 is activated.
 
Upvote 0 Downvote
Is x500 set to control all of the lines associated with the voicemail? This is done under General Admin/Service Modes in R1T1 software. Each line you want voicemail to answer in night mode must be assigned to the control set x500.

Brian Cox
Georgia Telephone
 
Upvote 0 Downvote
I have target line 121 assigned x500 is the control set, voice mail DN is 253.
Can you give me a step by step? I am missing a step or two.
Thanks
 
Upvote 0 Downvote
I think you don't have ringing sets programmed. The next heading after Control Sets is Ringing Service. Show this and program Mode 1 to manual. Press NEXT until you see a prompt to Enter Line. You then program your ringing sets in night mode for each line.

Brian Cox
Georgia Telephone
 
Upvote 0 Downvote
They have a T1 in place so shouldn't I just have to program the main target line number? What about the voice mail DN should that be included somewhere?
I am going to the site this AM and will try the things you mentioned so far.
Thanks
 
Upvote 0 Downvote
It depends on how the T1 is configured. If the T1 provides loop start or wink start lines you will program lines 001-024 in Control Sets. If it's providing DID service you will program Target Lines 121-xxx in Control Sets. The voicemail DN will be included under ringing sets. That will make it answer immediately in night mode.

Brian Cox
Georgia Telephone
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

highgravity
  • Locked
  • Question Question
External night ringing service
Replies
3
Views
556
curlycord
curlycord
jsaad
  • Locked
  • Question Question
Service mode?
Replies
2
Views
953
jsaad
jsaad
P
  • Locked
  • Question Question
Incoming calls go to dial tone on Nortel MICS-XC 7.0
Replies
11
Views
1K
curlycord
curlycord
STTP
  • Locked
  • Question Question
Norstar night service
Replies
5
Views
586
phoneguy427
phoneguy427
roycep
  • Locked
  • Question Question
Nortel Norstar: Remove one extension from night ringing group
Replies
3
Views
663
roycep
roycep

Part and Inventory Search

Sponsor

Back
Top