I've never seen this before, the (WS5A) workstation display is fine for bios/post then when CE loads the display goes dark.
If I attach a VGA monitor, it shows desktop, etc. and I can move cursor using the touchscreen (even though the touchscreen display is not showing anything).
I did a CE factory reset from bios and I downloaded the ELO CE drivers (although I'm not exactly sure where/how to install them).
Anyone have any suggestions? Thanks!
If I attach a VGA monitor, it shows desktop, etc. and I can move cursor using the touchscreen (even though the touchscreen display is not showing anything).
I did a CE factory reset from bios and I downloaded the ELO CE drivers (although I'm not exactly sure where/how to install them).
Anyone have any suggestions? Thanks!