Micros KDS services keeps stopping 1

[mrmicros]

When you boot ksd it loads to white screen as services not running. Start services and it loads but then in 30 seconds shows no network. Check services and stopped again. On server start services and can watch it stop in a minute.
Logged on as admin with all privileges.
Windows 7 RES 5.1

 

[Moregelen]

Do you have the server as the controller? Does the server have more than one NIC? If it has more than one NIC, make sure that the NIC that micros is routing through has priority or the service will stop because micros is dumb and just does a get on the first IP address of the computer, checks if it matches the KDS Controller's programmed IP address, and stops the service if it doesn't. More than one NIC will cause this if you haven't set their priorities.

 

[mrmicros]

That's it! Many thanks. had similar issue over a year ago. you don't use it you lose it when not embedded into your brain.