Micros 3700 - Template issues adding wks5 to wks5A environment

[Serenitee]

I have a location with all workstation 5A's that recently bought a workstation 5 to add to their Micros 3700 layout.
I have gotten the workstation 5 to cal correctly however there are issues with missing screen templates, etc.
I was assuming I should copy everything that is in the Micros server's WKS5A cal directory into the WKS5 directory and then re-cal the wks5 but am not sure this is best practice.
Does anyone have any tips / advice?
Any feedback is appreciated. Thank you!

 

[Serenitee]

I tried copying everything that was in the [\RES\CAL\] WS5A directory into the WS5 directory but the workstation failed model check when I tried to re-cal. I reverted the back to original contents of WS5 directory, copied only the contents of 'bitmaps' and 'ETC' sub-directories (from WS5A to WS5). Re-cal the workstation and I am back to where I began with template issues. I know that the templates the workstation is complaining about are custom screens (a bar speed and a table screen) but am not sure how to proceed.