Hello. I Have some odd problem coming from a KDS unit that was not fully installed, or fully programmed (one of the problems is I cannot change anything about devices as I receive a key violation saying that my production levels on my KDS are wrong)
Since I cannot remove the KDS through devices because of this, I am at a loss as to how to remove the KDS to regain control of the device table in Micros (win 10, 3700, 5.75Mr6).
Would anyone happen to have documentation on removing a KDS or any suggestions as to the steep tp take?
Thank you in advance!!
Since I cannot remove the KDS through devices because of this, I am at a loss as to how to remove the KDS to regain control of the device table in Micros (win 10, 3700, 5.75Mr6).
Would anyone happen to have documentation on removing a KDS or any suggestions as to the steep tp take?
Thank you in advance!!