microline printer hooked to a g3 mac.

[millieboppers]

Hi everyone... just wondering about hooking a Microline 321 turbo- 9 pin to a G3 mac computer?.. the printer has a serial port and the computer has a usb port... can I make this work some how? and then what about drivers and software? any advice would be greatly appreciated...

Millieboppers

 

[rockerfellerz]

PowerPrint is a hardware/software solution that might work but I think it's quite expensive. Check it out at :

http://www.strydent.com/

Macs' generaly won't work with printers that don't support postscript unless there are specific drivers for the mac for that printer....

If you're going through Hell...keep going... (Winston Churchill)
RocKeRFelLerZ