Hello everyone, We have two micom marathon 5kt pro's with the voice over technology. We currently connect the remote micom via a dedicated data line via the A1 port connected to a kentrox modem. the data line is very expensive and we have decided route over the internet instead so I got two IRM router boards one for the local and one for the remote micom. I am thinking of connecting them to the hub and then configure our internet router to treat the micom as a special protocol. How would i go about doing this? Is it at all possible?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Micom Routing over the internet
- Thread starter FSC729
- Start date
Guest_imported
New member
- Jan 1, 1970
- 0
- 0
- 0
i would not advise that , the micom routing engine does not like it and you will experience major problems, plus i am not sure it can be done cos of the ppp passwords.
Try using a cisco 800
Try using a cisco 800
Guest_imported
New member
- Jan 1, 1970
- 0
- 0
- 0
Hello:
Not sure if you still have your Marathon. If you do,
the Marathonstore has a new product called the
"magnum router" and that will allow all legacy
MICOM traffic to go via "ethernet" to any "IP"
connection.
Not sure if you still have your Marathon. If you do,
the Marathonstore has a new product called the
"magnum router" and that will allow all legacy
MICOM traffic to go via "ethernet" to any "IP"
connection.
- Status
Similar threads
- Locked
- Question