MiCollab Meeting Center on 6940 phones using MiCollab 8.1.2.8 not working

[TCSI17]

Has anyone been able to get this working; a button added on to the 6940 phones to use the MiCollab Meeting Center application on the 6940 to display audio conference meetings?
I've followed the guide and everything seems to check out, yet no meetings show up on the 6940 when I press the assigned button.
MiCollab on desktop reflects the status of my Outlook calendar, and checking permissions in Exchange show that my impersonation is working.

 

[TCSI17]

UPDATE: After searching around on KMS, I finally found a doc that fixed my issue. I needed to SSH into MiCollab and run a specific command to reset the webapp auth password.
Once I did that and restarted tomcat on MiCollab it worked! This confirmed that following the manual for configuration indeed worked ok.
I needed to wait a couple minutes for MiCollab Meeting Center to load, but it works fine now.
So basically the setup is all in the MiCollab Client Administrator manual (except for the auth issue above). Referencing the manual, I did need to add the MiVB PAUSE parameter to the file. It wasn't there by default and didnt seem to be pausing properly. See the manual for proper directions on setting this PAUSE parameter.

 

[kwbMitel]

Thanks for sharing the solution