Micollab Can I Use one Public IP to connect to the firewall and Micollab 2

[voipneerd]

Hi All

I've only one Public IP address. Register with Dyn DNS.

If I type the DNS name followed by :4444 I can access my utm and also the VPN is working fine.

I've New Mitel Micollab server installed in my network (192.168.1.17). and I want to access this server from outside and Allow the mobile client to access the server from outside.

How can I achieve it?

UTM 192.168.1.12
Micollab 192.168.1.17
I only have one public IP address for example 10.10.10.10

 

[TCSI17]

Hi,
The easiest most effective way to achieve this in my opinion is to get a Mitel MBG.
With the MBG, you can put it in the DMZ, or even give it a public IP (if you happen to get another one). You can set MBG up as a proxy so you can access devices such as MiVB and MiCollab from outside the network.
This is achieved by using split-DNS (using the same DNS name outside and inside your network).
If you are using MBG with another public IP, then you can just add a virtual 3rd adapter to MBG and set it up in the server-gateway mode. MBG is only a virtual appliance i believe so you will need to have VMware.
In your case, putting it in the DMZ would be the way to go. MBG handles all the interactions with MiCollab to get your mobile clients working. You wouldnt need to do specific port forwarding in that case.

 

[voipneerd]

HI TCSI17
for MG in DMZ what will be the set side ip address

BR

 

[TCSI17]

You need to go in and set the 'set-side streaming address' to your public IP on your firewall. the ICP streaming address should be the IP of your MBG.
Think you need to change the server mode to custom - it may detect that automatically after you change the IP though.