Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

MICB Call Out Group

Status
Not open for further replies.

shortcircuit42

Technical User
May 16, 2010
5
US
I have MICB cards (NT5D51AC & NT5D51BC) on a CS1000 switch. If the MICB cards are configured with normal dial-in conferences, it works fine on all ports. Recently, I have a need to setup a permanent conference that when dialed into initiates an emergency Call Out Group. Everything works the way it should with exception to the fact that it does not Call Out on any conference ports past number eight. The Call Out group can be small, 2 or 4 numbers. It is the port that it accesses to call out that is the problem. If I enable any ports on the MICB card past port 8, and dialing into the card accesses port 8 or higher, then the outgoing call fails. No audible indication, the call just does not go through. If I have only the first eight ports enabled on the MICB for the conference to select from, everything works perfectly.

Any ideas?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top