MGCR prompt-ref thread798-245592

[ArrJay21]

How do you change the "MGCR" value? When I try to change it, it takes me to "NCR"?

 

[EddieDuece]

MGCR 0-NCR Maximum number of call registers used by AUX
messaging.
MGCR is associated with the NCR prompt. It is
the maximum number of call registers that can be
queued for use by AUX messaging before extra
processing time is allocated to handle them.

NCR xx Number of Call Registers, range depends on system
type. Where:
• xx = 26-2047 for System Option 51C
• xx = 26-20000 for System Option 81C
The maximum number of call registers may be limited
by the amount of system memory. In this case the
number of call registers is the amount of protected
memory available divided by the number of words per
call register

 

[ArrJay21]

I have an 4 cabinet Opt11c with a 8 port CallPilot. My MGCR value is set to "NULL" and I can't change it. When I try to change PARM it skips by the MGCR prompt. Is there another change I have to make in order for it to appear?

 

[EddieDuece]

Do you get this far?

REQ chg

TYPE parm

LPIB

HPIB

500B

SL1B

NCR

You need to define NCR to get the prompt I believe.

 

[ArrJay21]

Yes, I got that far, but it never gives me the "MGCR" prompt.

 

[jamie2]

What are you trying to do?

 

[ArrJay21]

Make the MGCR prompt not NULL