MGCP Problem

[bladeka]

Dear All :

Am using CCM version 4.0 with a 4FXO going to a MGCP gateway an E1 module going to a H.323 ,, am using a call accounting software ,,

I want to monitor the outgoing calls on the 4FXO port ,,

my problem is i want a command or translation on the router that remove the 9 before the phone number on a MGCP port from the router not from the CCM ..
her is part of my configuration ,,,
!
!
mgcp
mgcp call-agent x.x.x.x service-type mgcp version 0.1
mgcp dtmf-relay voip codec all mode out-of-band
mgcp modem passthrough voip mode nse
mgcp bind control source-interface FastEthernet0/1.1
!
voice-port 1/0/0
!
dial-peer voice 703 pots
application mgcpapp
port 1/0/0

can that be done ?

 

[commsguy]

when using MGCP all pattern and dial string manipulation happens on the CallManager. You can apply this to your dial plan.

commsguy

http://www.convetech.com