MGC not registering correctly

[Harlock1]

I found part of my problem from previous post on ACOD.

I am using 1120's phones, they register fine and I can call between sets.
I have a CS1000E cores system, R6.
MGC is 004
DSP's are 96 + 32
My TLAN is 10.10.122.120
DSP96 is 10.10.122.121
DSP32 is 10.10.122.122

I can ping the TLAN for MGC but not the DSP's
The card (MGC) displays errors on the console regarding token problems.
in LD 32 if I stat 4 0 11 all the timeslots/dsp are disabled.

If I enable it, it says card not responding.

Do I need to have the card registers under LD 117 with "reg ucm system"? Because if I do it fails.

Stumped here.

How can I force download / enable / register the mgc card?
It seems to work ... sort-of

 

[lexer]

Did you configure MGC using port 0 on the card?

 

[Harlock1]

Yip, serial you mean?

 

[Harlock1]

Ok, figure out the problem, I had to use a Ctrl OAM command, with admin2 user/password.

Then I had to do a security domain join, but not using the TLAN, instead the ELAN ip for UCM ... strange ...

But now its working ... now my next problem, I get the OVL824 password error on cslogin/csconsole, how do I reset the password?

Will do a new thread.

 

[mitnorpbx]

I believe once the system joins the security domain admin1 and admin2 will only work if the UCM is down. You have to log into UCM and create new users and give them acces to what applications they need.

 

[Harlock1]

Thanks, works as you specified, have to add new users and use them instead of "old" admin1 / admin2 etc.