MGC can not call from Analog set to IP Set

[tnphoneman]

Has anyone seen this message on the MGC card? Make a call and connect for about 3 seconds and then it disconnects.

02/04/2009 11:20:41 LOG0003 VGW: VGW2118 VGW Connection setup failure : MAC address configuration unsuccessful (target device not responding), call failure on channel: 97 (51)

I get an Err008 on the PBX listing the analog tn and the dsp tn.

I have 4 MGC cards I have rolled between cabinets and 3 DB32 cards. I can't have that many bad parts even for Nortel.

Signature===========================================

http://www.greatwhitetechnologies.com

Aastra Authorized Reseller

 

[tnphoneman]

Forgot to mention 5.5 geo redundant site. and yes it is registered to the main call server.

Signature===========================================

http://www.greatwhitetechnologies.com

Aastra Authorized Reseller

 

[biv343]

if you stat the DSPs, do they show as idle or disabled? Can you ping the TLAN IP of the MGCs and daughterboards from the TLAN VLAN?

 

[biv343]

One other thing. Are you using dual homing on the MGCs? If so, disconnect either the front or back MGC cables, have someone flush the arp table in the switch then try again. I've seen issues with dual homing in certain environments.

 

[tnphoneman]

Yep all enabled and idle and pingable

Signature===========================================

http://www.greatwhitetechnologies.com

Aastra Authorized Reseller

 

[tnphoneman]

After several prople looking at the configs I finally spotted an incorrect IP address on the MGC TLAN. 4 pairs of eyes and 3 days later.

Signature===========================================

http://www.greatwhitetechnologies.com

Aastra Authorized Reseller