MFV over IP Trunk between TSW and BP

[LIMSwitch]

Hi,

we have two Systems connected with an IP-Trunk. One Site is TSW SP6 and the other Site is BP R16. Everything goes fine.

We want to dial through the IP Trunk to the PSTN Line on the other site. The first Step is from TSW to BP.
If we dial the destination code to the BP followed by the destination code to the pstn we get a dial tone. I think it is not the tone from the PSTN but from the BP.

Then we dial the external number, but nothing happens. We continuesly receive the dial tone. Does everyone have any experience on this?
Our Mx-One config
<rodap:rou=65;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
65 TL65 H'00000100 H'00000011 H'00000001 NO

END

<rocap:rou=65;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
65 0120000000000010 5 3110000001 0 30 128 00151510 011101000091 111111

I don't know which BP Parameter depends to the Trunk Configuration.

Thanks

 

[LIMSwitch]

Hi again,

it works now, nanls was set and i delete it.

Thanks