MFIM 50B with P-P problem

[xs650]

Hello,
I am totally new with IPECS MG and LIK so please be patient when my questions are a little bit confusing or unclear in the first time

I have a problem with a MFIM 50B with one external P-P interface, I neither can dial outside nor into the MFIM.
With a P-MP I can make outgoing and incoming calls but not with a P-P.

What I have done:
-Tei is set to fixed
-CO groups of the not used interfaces are set to 21
-DID remove number set to 7 (national number plus subscriber number is 7)
-DID conversion type is set to "use as is"

Where is my mistake or what do I have forgotten?
Thanks in advance
XS

 

[abl2910]

Hello

When you call in what do you get, the voice, number not valid and the call go to operator or what

this is a good ide to save and reboot, when your fidling with co-lines


abl2910

 

[xs650]

Hello,

the restart was a good idea, now I can make outgoing and incoming calls.

Now at incoming calls it is allways the operator ringing, do you have one more tip what I have programmed wrong?

Thanks in advance
XS

 

[abl2910]

Hello

If the operator get all call is because the ddi (prg231) is wrong, normaly it is the last 3 digits in the number ex.
12345678 then in prg 231 on index 678 is pointing on a ext.number or group
In DK we remove 5 digits and use 3 for ddi.

abl2910

 

[xs650]

Hi,
many thanks, incoming calls are working now but at outgoing calls the DDI is not send to the external party.
Where can I set that the systems sends the DDI?
BR
XS

 

[abl2910]

Hello
last ex. the number 12345678 you use the last 3 digi and now the first 5 digi is used in prg 201 clip/colp 1 is 12345

Then in station programming(ex. sta 100) prg 114 cli station nr is 678

then sta 100 will show 12345678

ex. sta 101 prg 114 CLI station nr. is 999

then the sta 101 will show 12345999

if the 5 digi(prg201) plus 3 digi (prg231) is not valid the main number is showing

abl2910

 

[xs650]

Many thanks, it is working now (I have forgotten to program prg 201 clip/colp table).
BR
xs