Hello, all
some last Problems in our system:
1. a working, linked (by networking) System of a Mfim 50b with a Mfim 300; the mfim 50 use co lines from the mfim 300 over voip;to get this transit co line, we have to dial at the Mfim 50b stations: 84-0 and then a following complete number; i.e. 84(transit route to mfim 300) 0(trunk tone) 029xxx(local prefix) 123456 (called number); that works;
now we need diversion to mobile or extern numbers on the stations; when trying ,to programm a diversion to extern or mobile number (over speed dial system numbers in system PGM ), and set diversion to this , it dont work; i suggest , there are Problems with handling the transit prefix 84-0 ?
2.next problem is: when extern calling comes to the mfim 50b, number is shown correct, but the leading "0" is cut/or missing ? where to recover or fill in?
(same reason, why we cannot dial direct out from caller list, where can we find settings for caller list? )
3.two problem on voice mail: is it possible, to get a (automatic) diversion to voicelmail/greeting after 4-5 rings without setting this manually over diversion to voicelmail ? - when a caller gets the personal greetings voicmail announcement from a diverted station, there comes a second short announcement ( in annother language) after he is able, to leave a mesage for the station; is is possible to delete this ?
thanks for any advice and greeting from germany
some last Problems in our system:
1. a working, linked (by networking) System of a Mfim 50b with a Mfim 300; the mfim 50 use co lines from the mfim 300 over voip;to get this transit co line, we have to dial at the Mfim 50b stations: 84-0 and then a following complete number; i.e. 84(transit route to mfim 300) 0(trunk tone) 029xxx(local prefix) 123456 (called number); that works;
now we need diversion to mobile or extern numbers on the stations; when trying ,to programm a diversion to extern or mobile number (over speed dial system numbers in system PGM ), and set diversion to this , it dont work; i suggest , there are Problems with handling the transit prefix 84-0 ?
2.next problem is: when extern calling comes to the mfim 50b, number is shown correct, but the leading "0" is cut/or missing ? where to recover or fill in?
(same reason, why we cannot dial direct out from caller list, where can we find settings for caller list? )
3.two problem on voice mail: is it possible, to get a (automatic) diversion to voicelmail/greeting after 4-5 rings without setting this manually over diversion to voicelmail ? - when a caller gets the personal greetings voicmail announcement from a diverted station, there comes a second short announcement ( in annother language) after he is able, to leave a mesage for the station; is is possible to delete this ?
thanks for any advice and greeting from germany
