MEW lamp at analogue phones

[trond456]

I have MD110 BC12SP10 integrated with diavox HSM, I'am facing a problem in the message waiting led at the analogue phones (Teledex and Ericsson analogue phones), it isn't working,while the message waiting lamp at the digital sets are working fine.

Parameters used:
EXCCP:CAT=1;EXTENSION CATEGORY CODE
CAT TRAF SERV CDIV ROC
1 01151515 0202120210 011150000 002001


END

<CNBIP:BPOS=1-0-00;
DEVICE BOARD REVISION INFORMATION
DATE: 25JUN06 TIME: 17:19:44

BPOS BOARD/BRDID PRODUCT NUMBER REVISION STATUS ADD
/IND

001-0-00 ELU30 ROF1375409/1 R1A

END
<ASPAPARNUM=45;APPLICATION SYSTEM PARAMETERS
PARNUM PARVAL
45 30
END
<ASPAPARNUM=88;APPLICATION SYSTEM PARAMETERS
PARNUM PARVAL
88 0
END
<ASPAPARNUM=190;APPLICATION SYSTEM PARAMETERS
PARNUM PARVAL
190 3
END
<EXDDPIR=114;EXTENSION DIRECTORY DATA
DIR CUST EQU CAT TYPE ICAT MCOST AUX
114 001-0-00-01 1 EL6 0040 (reverse polarity)

END

<EXCCP:CAT=1;EXTENSION CATEGORY CODE
CAT TRAF SERV CDIV ROC
1 01151515 0202120210 011150000 002001

Also I have tried EXCACIR=114,ICAT=0000;(voltage ramp)
with ASPACARNUM=190,PARVAL=3;
But no success message waiting lamp at analogue phones are not working .... So did anyone try before diavox with analogue phones (Teledex), if yes please help on this ...

But I'am receiving always the short periodic ringing every 5 minutes at the analogue phones......
what do u think guys
regards

 

[fouesnant]

Hi trond456

Strange : the ring signal indicates that the info MEW is present.
I have found some test that I made in the past on that type of board ('98 !)
Are you using a correct cable ie, line in 3/4 and MEW led in 1/6 of the RJ11 of the phone? (3-1 and 4-6 strap together)
According to my old databse, this is the way to connect the Teledex phones.
For my part I use ASPAP 190=0.

 

[trond456]

Thanks for the reply, I found out the solution by ASPACARNUM=88,PARVAL=5; (so it is ok now).

But another question did you try before the integration with fedalio throug diavox, if yes, how can the house keeping change the room status from phone? (cleaned , not cleaned)

Another question Is there any way to give the same directory number for analogue and digital extension, these extensions reside in the same room...
Thanks in advance