Message waiting indication for slt

[TomMcL2]

Does the partner ACS 7.0 have any kind of voice mail message indication for single line telephones, like a broken dial tone...
Thanks

 

[cvrbob]

yes it does Studder

 

[TomMcL2]

Question 2. Is that programmable or automatic, and will it work on the intercom.
I have 4 cordless telephones set to pick up on the intercom so they can call each other if needed. They just dial 9 for an outside line. When I tried an extension with a message I did not get the studder on ICM or when I dialed 9 for an outside line.

Any help is greatly appreciated.

Tom

 

[TouchToneTommy]

From the manual:

For message waiting capability, you must connect single-line telephones with LEDcompatible
Message Waiting Lights.


For message-waiting capability, single-line telephones with LED-compatible message-waiting
lights must be connected to a processor module, a 308EC module, or to an R3.0 or later 206
module.

On a single-line telephone, the message light flashes (only when the telephone is idle) to
indicate that the extension has received a message.

Partner does not provide stutter dial tone, however Legend/Magix does.

 

[Dexman]

I've tried to get the MWL on an AT&T 962 & Lucent 965 to function with a Partner ACS and Merlin Magix, but it was a no-go. I purchased a few Avaya 6221s and the MWLs function flawlessly.

The older Lucent/Avaya 2500 YMGM should work just as well.

I "FEATURE 00

 

[TomMcL2]

Thank you

Tom