Message Notification over PRI 1

[eartel]

We have a customer who would like to send Message Notification over thier PRI from a Call Pilot 150. They have a main sight and a point to point PRI to an off site with a MICS. What is needed to allow this feature?

EARTEL
888 416 4327
310 549 0387 Fax
rluna@eartel.net

 

[hawks]

If there are running the Point to Point as SL1 protocol and at level 6.0 software they should be able to do it.

 

[eartel]

WHAT ARE THE NECESSARY STEPS OR KEY CODES NEEDED FOR THIS PROCEDURE?

EARTEL
888 416 4327
310 549 0387 Fax
rluna@eartel.net

 

[hawks]

Is the point to point set up as SL1? What software are you running?

 

[eartel]

MICS 6.1 AND CALL PILOT 150 RLS 2.0. I DO NOT KNOW HOW THE POINT TO POINT IS SET UP.

EARTEL
888 416 4327
310 549 0387 Fax
rluna@eartel.net

 

[hawks]

Go into Hardware and look at how the card is programmed as you scroll through you'll see the Protocol. If you are running SL1 and you can call between the systems with no problem then all you'll have to do is set up a CDP between the 2. You should be able to Centralized mail with the 2 systems. I'll see if I can find the instructions but that should get you started.

 

[hawks]

Look at pages 156 thru 165 of the MICS 6.1 installer guide.