MerMail

[hosptech]

I'm trying to access my MerMail from home. I'm using Procomm.
The modem is not answering. I have a robotics 33.6 on MerMail. Does anyone know the settings for the modem?

Then I have procomm setup at VT-102 plus ZModem.


Thanks

 

[mluckie1]

Would suggest XModem. As far as modem setup refer to Meridian Mail install guide.

 

[DigitalG]

US Robotics Modem Setup connected to Meridian Mail

--------------------------------------------------------------------------------

This document is for US Robotics Sportster 14.4, 28.8, 33.6, & 56K modems.

To configure the U.S. Robotics Sportster modem, follow these steps.
Power off the modem.
Set DIP switches 1, 3, 7, and 8 to the down. (All other switches should be up).
Connect a terminal or computer running terminal emulation software to the modem.
Set the terminal or computer to the Baud rate of the Meridian Mail Console port, 8 Data bits, 1 Stop bit, No parity.
Turn the modem on and enter each command listed below with a carriage return (Press Enter or Return key).
Command
Response Description
AT&F0 OK Load active profile
ATS0=1 OK Answer after 1 ring
AT&B1 OK Fixed serial port baud rate
ATY0 OK Sets power on default configuration
ATQ1 None Sets modem to quiet mode
AT&W0 None Store to profile 0
AT&W1 None Store to profile 1

Power off the modem.
Verify that DIP switches 1, 4, and 8 are down (all the others should be up).
Power on the modem.


As per Nortel NTP Nov 1999