Merlin Messaging

[CommoGuy101]

Hi all,
I have a Cke5 processor R4.0 V7.0.
I am trying to get a Merlin Messaging to work but none of the port LEDs light.(Messaging R4 ... 4 port card)
Ofcourse none of the ports will answer after programming.
Will Messaging work with this release of processor.


Thank you all,

 

[merlinman]

Messaging will work just fine.

If this Messaging was just installed, I suggest you do a board renumber, and if that fails to bring it up, I would recommend that you check to see if the Messaging Slot is BUSIED OUT or not.

http://home.comcast.net/~merlinman

 

[tdaugirdas]

If - after a board renumber - the Messaging still fails to boot - you may have a defective hard drive - and/or messaging module. As long as it gets power - it should boot - with or without a board renumber. You can turn power off and back on - and listen for the hard drive starting up. The "status" light should show activity like a hard drive light on a PC. If the hard drive stops - after a bit - then the drive is probably defective. The green port lights will also all flash simultaneously during the boot process in inceasing frequency - and finally stop with just the licensed ports lit solid green.

Tom Daugirdas,
President
STCG, Inc.
stcg.com

 

[flyguy2]

How many carriers (cabinets)do you have? Did you just insert the card in a slot with the power on or did you power down the system>>>>>>insert the card>>>then power up left to right?

 

[bluemr2]

power up right to left.

 

[Dexman]

Welcome back Tom!

If it ain't broke, I haven't fixed it yet.