Merlin Magix PRI on DMS-100 Central Office

[CustomPhoneGuy]

Waht is the protocol being sent from a DMS-100 providing me with PRI? AT&T is the carrier and the CO is in Manhattan. I am receiving "D" Channel error with ESF, B8ZS, 4ESS and theyb are sending me 3 digits. Help! AT&T can't give me the proper set-up.

 

[netcon1]

If the CO is a 5ess switch then the translations should be NI-2 FROM THE co and the PRI set to 5ESS

If DMS100 is used IN THE co THEN the switch should be set to DMS100 and the protocol NI-1 from the CO.

The T1 parameters should be B8Z3 AND ESF

 

[franke]

Your provider should set you up as 'AT&T Custom' and not 'National', this is usually a big stumbling block.

franke