Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Merlin Magix Incoming Calls 3

Status
Not open for further replies.

PhoneMan02

Technical User
Nov 15, 2011
37
US
Ext 510
On incoming calls from outside the system, after a few seconds the calls line button will go out and then come back flashing as if its on hold. The user can reanswer the caller and the caller won't know she was gone they will be talking like the call was never interupted.
I have replaced the phone and station wiring.
 
Assuming this is a LEGEND, realize this. If you unplug and re-plug the set in during a call, it will go on hold.

You replaced the Set and the Station Wiring. Did you also replace the Mounting Cord?

Can you get the same failure at the control unit?

If so, it could be a bad Extension Port.



-merlinmansblog.blogspot.com
 
I stopped short.

There is also the MLX SELF TEST. Press INTERCOM (SA) then SPEAKER and then dial *00 (STAR ZERO ZERO). You should hear a loud (annoying) clear tone. Wiggle the CORD. If you hear snap crackle & pop, then your wiring is bad somewhere.



-merlinmansblog.blogspot.com
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top