Merlin Legend Install/Move system to new location 3

[Comput3rGuy]

I have a Legend system with two power supplies. They were in the basement of one of my schools the school is being remodeled and part of the remodel is a new server room/data room/phone switch room. The system worked before I moved it. Now that it is moved and up the way as before the 2nd power supply does not power on. What am I doing wrong or not doing? I am ensure that the second shelf is seated tightly and properly in to the 1st. I have swapped power cords, tried several different power sources and even a different power supply card. Hoping to get this up and running by Monday morning when the kids are do back in the building...Thanks for your advice!

 

[Telecomboy]

Power the expansion unit up first, wait a few seconds, then power the main cabinet up (right cabinet first, then left cabinet).

 

[Comput3rGuy]

that my friend is the problem I do beleive...I will get back to you!

 

[wireboy]

if the power led does not light up after moving, you may have broken the little plastic peg on the back of the second carrier.

42

 

[Comput3rGuy]

Is there any way around that little plastic leg on the 2nd carrier?

 

[TouchToneTommy]

Stick a B connector in the hole, or a screw, or part of a chopstick, whatever.

The idea is just to push in on the internal switch in the back of the power supply.

 

[pmcook]

Open the clamshell and use a small wire tie to close the switch.

 

[Comput3rGuy]

Thanks everyone. Indeed the small plastic dowell had been broken at some point and in fact whoever else has worked on the system had already used a small piece of wood to close the switch but it had come loose in the move...so at lunch I grabbed an extra set of chop sticks as was suggested above. System is fully up and working great! Thanks to all!