merlin board renumber - adding a 100d

[iskilam]

i have the following setup...
slot 0 - cke5
1 - 024 tdl
2 - 800 gl
3 - 800 gl
4 - 024 tdl
5 - 100d
6 - 024 tdl
7 - 024 tdl
8 - 016 trr
9 - 016 trr
10 - merlin messaging
11 - 100d
12 - 800 gl
13 - not used
14 - not used
15 - not used
16 - not used
17 - not used
i am planning to remove two 800 gl's and add a third 100d to reach the max. 80 lines for magix release 3...
pls advise on the best board arrangement...i tried removing the 800 gl's from slots 3 and 10 then installed the third 100d in slot 3 but i had difficulties in programming three 100d's eg. can't select channels from csu/dsu, cant select pri or t1 options etc...

 

[Ghostin]

Since you have to remove one of the 800 cards in the middle of the switch, all your lines and trunk assignments, types, t-1 types, etc. will need to be redone. It will take some time and a bit of programming.